Port to connect to an SCG200 when initial configuration

Summary

This KBA summarizes the type of ports we need to connect to an SCG when initial configuration

Question

Which port do I connect to on an SCG when initial configuration?

Customer Environment

SCG200 on 2.1 firmware.

Resolution

When we connect to an SCG from the first time or after a factory reset, we need to connect to a specific port. This will depend on the version of the SCG, but we can find two different situations:
Default IP of SCG after factory reset is always 192.168.2.2:

Old SZ versions (like 2.1.3): Connect to SCG CONTROL interface, ETH0 (lower down left port)
New SZ versions (like 3.4.1): Connect to SCG MANAGEMENT interface, ETH2 (upper left port)

After this you can continue connecting with a browser to http://192.168.2.2:8080

SCG200 ports

Article Number:
000006371

Updated:
December 08, 2018 03:11 AM (about 6 years ago)

Tags:

Votes:
0

This article is:
helpful
not helpful