CLI command to reset the standalone AP to factory default settings
Summary
Factory reset of standalone AP from CLIQuestion
How to factory reset standalone AP from CLI modeCustomer Environment
Standalone APResolution
Log-in to the AP CLI using Putty application.
set factory is the command to reset the Standalone AP to factory default settings.
rkscli: set factory
Factory defaults will take effect after reboot
OK
rkscli: reboot
Rebooting... please wait.
Once the AP is rebooted the AP will goes to factory default settings with an IP address of 192.168.0.1.
Note: If there is a DHCP server in the network then the AP will be obtaining IP address from the DHCP server as APs are DHCP clients. A good best-practice is to statically assign IP addresses using MAC address mapping on your DHCP server so that you have a reliable IP address to refer to when accessing an AP.
Once the AP is rebooted the AP will goes to factory default settings with an IP address of 192.168.0.1.
Note: If there is a DHCP server in the network then the AP will be obtaining IP address from the DHCP server as APs are DHCP clients. A good best-practice is to statically assign IP addresses using MAC address mapping on your DHCP server so that you have a reliable IP address to refer to when accessing an AP.
Article Number:
000002448
Updated:
August 14, 2020 03:45 PM (over 4 years ago)
Tags:
System Network Management, ZoneFlex Indoor, ZoneFlex Outdoor
Votes:
24
This article is:
helpful
not helpful