Toggle AP LEDs in SZ environment

Summary

LEDs are turned off but there are a couple of ways to enable/disable lights on the vSZ controlled APs.

Question

How do I enable/disable LEDs of vSZ managed APs?

Customer Environment

vSZ, vSCG, SZ100 managing any model APs.

Resolution

There are two locations where you can disable/enable LEDs of APs of a vSCG/SZ controller.
You can disable/enable LEDs for an AP Zone per model of that Zone or you make the change AP specific.

For AP Zone model-specific:
- Go to Access Points > AP Zones, then choose the Zone.
- Go to the AP Model Specific Configuration, select an AP Model
- Then on the Status LEDs either disable or enable, to disable or enable LEDs

For AP specific:
- Go to Access Points tab and locate the AP mac that you want to enable/disable LED
- Click on Model Specific Options, select Override zone configuration
- Then select to disable or enable LED.

Exception: If you have an SCG200 or vSCG/SZc and the AP is in a staging zone, you will not be able to make this change while the AP is in the staging zone.

Article Number:
000005476

Updated:
August 13, 2020 06:53 AM (over 4 years ago)

Tags:
Configuration, Installation, Troubleshooting, ZoneFlex Indoor, ZoneFlex Outdoor, SmartCell Gateway, SmartCell AP, virtual SmartCell Gateway

Votes:
2

This article is:
helpful
not helpful